Size: 10.3 oz
Units per case: 12
1. Clean surfaces thoroughly.
2. Apply thin even bead (1/8”) to one surface.
3.Assemble parts immediately while silicone is wet. Finger tighten bolts, allow to set for 1 hour before torquing bolts to torque spec.
4. Clean excess with a knife or non-flammable cleaning fluid.
Sealant is fully cured in 12-24 hours. After use, replace cap.
Contains petroleum distillates.
Uncured sealant causes eye and skin irritation. Acetic acid is released during curing. Use only outdoors or in a well-ventilated
area. In case of skin contact, wipe off and wash with soap and water. In case of eye contact flush with water for 15 minutes,
get medical attention.
If swallowed, DO NOT induce vomiting. If overcome by fumes, get fresh air. See Safety Data Sheet for
complete GHS hazard communication.
KEEP OUT OF THE REACH OF CHILDREN.