Menu
Size: 0.84 oz (25ml)
Units per case: 12
1. Roughen, clean and dry all surfaces to be bonded or repaired.
2. Turn nozzle end up and pull plunger back slightly (1/8″). Allow air bubbles to rise to top. Snap off and save storage cap.
3. Push plunger to dispense equal amounts of hardener and resin onto a discardable surface such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger to stop flow. Snap on cap.
4. MIX THOROUGHLY with paddle provided and apply to surface. Bond sets in 2 hours and item can be handled in 4-6 hours. Full strength in 24 hours. Low temperatures lengthen set time.
5. Wipe nozzle clean. Storage cap snaps on one way only.
NOTE: Not recommended for use above 250°F (121°C). Does not bond to Polyethylene or Polypropylene Plastics.
Harmful if swallowed or in contact with skin
Nocivo en caso de ingestión o en contacto con la piel
Causes severe skin burns and eye damage
Provoca quemaduras graves en la piel y lesiones oculares graves
May cause an allergic skin reaction
Puede provocar una reacción alérgica en la Piel
